BONFIGLIOLI Agile Operating Instructions Manual page 184

Analog: Source MFO1A
Abs. Val. PLC-Output Per-
61 -
centage 1
Abs. Val. PLC-Output Per-
62 -
centage 2
101 to 162
By default, the multifunction output is configured for the output of a pulse width modulated output
signal with a reference voltage value of DC 10 V.
554 Digital: Source MFO1D
If the multifunction output is to be used as a digital output, parameter
550 must be set to "1 - Digital MFO1D".
(X13.6)
For parameter
Digital: Source MFO1D
be selected.
Parameters
Operation mode MFO1
550
(X13.6)
Digital: Source MFO1D
555 RF/PT: Output Value MFO1F(repetition frequency/pulse train)
Multifunction output MFO1 can be used as a frequency output. Parameter
550 must be set to "20 - Repetition Frequency (RF) MFO1F". The output signal can be select-
(X13.6)
ed via parameter
RF/PT: Output Value MFO1F
Parameters
Operation mode
550
MFO1 (X13.6)
RF/PT: Output Value MFO1F
0 - Off
1 - Actual Frequency
2 - Stator Frequency
5 - Repetition Frequency Input
The maximum frequency value output is:
f 2 (
= ×
Maximum
outp. max
Scaling
If the multifunction output is set as a frequency output, the output frequency can be scaled. Parame-
ter
Operation Mode MFO1 (X13.6)
556 RF: Division marks (repetition frequency mode)
The repetition frequency mode for the multifunction output corresponds to the emulation of an incre-
mental sensor. The parameter
quency to be output.
Agile
Operating Instructions
553
Output value "2521 – PLC Output Percentage 1" of a PLC-
function is output via the multifunction output. Refer to applica-
tion manual "PLC".
Output value "2522 – PLC Output Percentage 2" of a PLC-
function is output via the multifunction output. Refer to applica-
tion manual "PLC".
Operation modes in analog operation with signs.
554, the signal to be output at the multifunction output can
Factory setting
10 - Analog (PWM) MFO1A
554
4 - Setting frequency
(Refer to 7.6.5.2 "Setting
frequency".)
555.
Factory setting
10 - Analog (PWM) MFO1A
555
Repetition frequency mode switched off.
Abs. value of the
Factory setting.
Abs. value of the
Abs. value of the
419 ) (
×
Frequency F
R
550 must be set to "20 - Repetition frequency (RF) MFO1F".
RF: Division marks
184
06/2013
Function
1 - Digital MFO1D
Select a digital signal source.
(Refer to 7.6.5 "Digital outputs",
table "Operation modes for digital
outputs".)
20 - Repetition Frequency (RF) MFO1F
Function
Actual frequency
Stator frequency
Repetition frequency input
556 )
: Division marks
556 must be parameterized according to the fre-
Parameter descriptions
Operation Mode MFO1
Set
Operation Mode MFO1
Set
241.
210.
252.
Control inputs and outputs