BONFIGLIOLI Agile Operating Instructions Manual page 255

Parameter descriptions
Messages
No memory card plugged.

No file with parameter values on memory card.

Parameter values were saved on memory card.

Parameter values were uploaded to frequency inverter.
Insufficient memory. The parameter values were not copied to the memory card com-

pletely.
No more file numbers available.

Error while writing on the memory card.

Error while reading from the memory card.

Data content invalid.

Fault when loading from memory card, memory card has contact problems. Contact

mounting of card.
Error while writing parameters of LOAD functions. Non-permissible parameter value.

Error while writing parameters of LOAD functions. Non-permissible parameter set.

Error while writing parameters of LOAD functions. Non-permissible write access.

Error while writing parameters of LOAD functions. Write error EEPROM.

Error while writing parameters of LOAD functions. Checksum error EEPROM.

Error while writing parameters of LOAD functions. Value is only allowed to be written at
inhibited state.
Error while writing parameters of LOAD functions. Error parameter type.

Error while writing parameters of LOAD functions. Unknown parameter. The mentioned

parameter is not contained inside the target device.
If an error occurs in the LOAD function while the parameters are written, the error number and the
parameter number will be displayed alternately.
− Press button "ENT" to continue the function.
− Press button "ESC" to cancel the function.
Please check the compatibility of different firmware versions when copying parameter
sets between different devices. When copying from a device with a newer firmware
version into devices with older firmware versions in individual cases the warning mes-
sage "Err 111" may appear.
The market software of the Agile device series is downward compatible. Data from
devices with older firmware versions can be transferred to devices with newer firm-
ware.
Parameters are always saved in control level 3 "Professional" on the memory card.
This is independent of the currently selected control level.
Special functions
255
06/2013 Operating Instructions
Agile