BONFIGLIOLI Agile Operating Instructions Manual page 193

Parameter descriptions
Create warning mask
0 - No change
1 - Activate everything
2 - Activate all Warnings
3 - Activate all controller states
10 - Activate Warning Ixt
Activate Warning short-term
11 -
Ixt
Activate Warning long-term
12 -
Ixt
Activate Warning heat sink
13 -
temperature
Activate Warning inside tem-
14 -
perature
15 - Activate Warning limit
16 - Activate Warning Init
Activate Warning Motor
17 -
Temperature
Activate Warning Mains Fail-
18 -
ure
Activate Warning Motor Pro-
19 -
tective Switch
20 - Activate Warning Fmax
Activate Warning analog
21 -
input MFI1A
Activate Warning analog
22 -
input MFI2A
Activate Warnings system
23 -
bus
24 - Activate Warning Udc
25 - Activate Application Warning
Activate Warning Controller
30 -
Udc Dynamic Operation
Activate Warning Controller
31 -
Shutdown
Activate Warning Controller
32 -
Mains Failure
Activate Warning Controller
33 -
Udc Limitation
Activate Warning Controller
34 -
Voltage Pre-Control
Activate Warning Controller I
35 -
abs.
Activate Warning Controller
36 -
Torque Limitation
Activate Warning Controller
37 -
Torque Control
38 - Activate Warning Ramp Stop
Control inputs and outputs
536
Configured warning mask is not modified.
The warnings and controller status messages stated are linked
in the warning mask.
The warnings reports stated are linked in the warning mask.
The controller status reports stated are linked in the warning
mask.
The frequency inverter is overloaded
Overload reserve for 1 s minus the
405 has been reached.
Ixt
Overload reserve for 60 s minus the
406 has been reached.
Ixt
Max. heat sink temperature T
407 reached.
sink temp.
Max. inside temperature T
408 reached.
temp.
The controller stated in
ence value.
Frequency inverter is being initialized
Warning behavior according to parameterized
Mode Motor Temp.
Phase Supervision
Operation Mode
The
Maximum Frequency
limitation is active
The input signal at analog input MFI1A is less than 1 V/2 mA
in accordance with operation mode
Error/Warning Behaviour
The input signal at analog input MFI2A is less than 1 V/2 mA
in accordance with operation mode
Error/Warning Behaviour
A slave on the system bus signals an error.
The DC link voltage has reached the type-dependent mini-
mum value.
A warning application is signaled.
Controller is active according to
The output frequency in the case of a power failure is below
the
Shutdown Threshold
Failure of the mains voltage and power regulation active ac-
cording to
Operation Mode
The DC link voltage has exceeded the
680.
Limitation
The
Dyn. Voltage Pre-Control
characteristics.
The output current is limited.
The output power or the torque is limited by the speed con-
troller.
Switch-over of field-orientated control between speed and
torque-controlled control method.
The
Operation Mode
the output current.
193
Function
Warning limit short-term
Warning limit long-term
minus the
K
minus the
Warning limit inside
K
Controller Status
570 at maximum motor temperature T
576 reports a phase failure.
571 for motor circuit breaker triggered.
419 was exceeded. The frequency
453.
563.
Operation Mode
675.
670 for the voltage controller.
Reference DC-Link
605 accelerates the control
620 selected in starting be-havior limits
06/2013 Operating Instructions
Warning limit heat
275 limits the refer-
Operation
PTC.
670.
Agile