BONFIGLIOLI Agile Operating Instructions Manual page 210

654 Pulse Train Scaling Frequency
The pulse train (pulse sequence) signal at digital input IN2D (terminal X11.5) is scaled. Via parameter
Pulse Train Scaling Frequency
419. A read frequency of
Maximum Frequency
train input, a frequency with the value of the scaling factor is applied.
Parameters
No. Description
654 Pulse Train Scaling Frequency
If parameter
Pulse Train Scaling Frequency
input will not be scaled.
Parameter
Repetition Frequency/Pulse Train
Pulse train signal on IN2D as reference value:
Reference Frequency Source 1
Reference Frequency Source 2
496
Operation mode IN2D
Pulse Train Scaling Frequency
IN2D X11.5
Reference frequency value:
Maximum
f f
= ×
reference IN 2 D
Pulse Train
(Maximum Frequency
Example:
Input frequency at IN2D: f
Reference frequency value:
= 0
Pulse Train
= 25000
Scaling Fre-
654
quency
Output as percentage
In the case of a parameterization as a pulse train, the read frequency value is also available as a per-
centage for the reference percentage channel. 0 ... 100% correspond to the signal frequency range 0
...
Maximum Frequency
mula:
Percentage value =
Maximum
Agile
Operating Instructions
654, you can set which input frequency corresponds to the value of
Min.
0
654 is set to zero, the frequency value at the digital
252 shows the actual value of pulse train input.
475 or
10 - Repetition Frequency
492
30 - Pulse Train
654
The scaled pulse train signal is the reference frequency
value.
P496 30-Pulse Train
P654 Hz
419
Frequency
654
Scaling Frequency
Factory setting
f [Hz]
Reference
419
) 50
10
5000
Example
= 5000 Hz
IN2D
f = f (5000 Hz), limited to 50 Hz (
reference IN2D
f = 10 Hz
reference
419 at the pulse train input. The conversion is done using the following for-
Frequency value
× 100
419
Frequency
06/2013
419 means that at the pulse
Maximum Frequency
Setting
Max.
32000
f
reference
[Hz]
P654=25000
25000
f [Hz]
IN2D
(Pulse train scaling frequency
Maximum Frequency
%
210
Parameter descriptions
Fact. sett.
25000
654
)
419)
Control inputs and outputs