BONFIGLIOLI Agile Operating Instructions Manual page 330

No. Description
350 Status of digital inputs
351 Status of digital outputs
352 Time since release
353 Heat sink temperature
354 Inside temperature
355 Controller status
356 Warning status
357 Int. value 1
358 Int. value 2
359 Long value 1
360 Long value 2
Application Warning
367
State
361 Checksum
The 361 parameter shows whether the storage of the error environment was free of errors
Checksum
(OK) or incomplete (NOK).
No. Description
361 Checksum
Agile
Operating Instructions
Error environment
Decimally encoded status
− of the enable signal (STOA AND STOB)
− of the six digital inputs and
− of multifunction input 1 (if
digital NPN (active: 0 V)" or "4 - digital PNP (active: 24 V))" and
− of multifunction input 2 (if
"3 - digital NPN (active: 0 V)" or "4 - digital PNP (active: 24 V))".
Decimally encoded status
− of digital output at terminal X12.5.
− of multifunction output at terminal X13.6 (if
550 = "1 - Digital MFO1D"
MFO1 (X13.6)
− of digital input/output at terminal X11.6 (if
558 = "1 - output OUT3D")
minal X11.6
− of relay output at terminal X10
Time of the error in hours (h), minutes (m) and seconds (s) after
enable signal:
sec sec sec
hhhhh:mm:ss . / /
10 100
Measured heat sink temperature.
Measured inside temperature.
The reference value signal is limited by the controller coded in the
controller status.
The warning messages coded in warning status.
Software service parameter.
Software service parameter.
Software service parameter.
Software service parameter.
The application warnings coded in warning status.
Error environment
Function
Check protocol of the error environment.
330
06/2013
Function
Operation mode MFI1
Operation mode MFI2
Operation mode
Operation mode ter-
.
/
1000
Error protocol
452 = "3 -
562 =
Error environment