BONFIGLIOLI Agile Operating Instructions Manual page 206

On the output, the logic signal 927 - "Output MUX" for the inputs of the TxPDO process data of the
system bus or for PZDx-IN process data of the Profibus can be
Parameter
1252 Mux Inputs
1250 Mux Input Index (write)
1251 Mux Input index (read)
The parameters
Mux Input Index (write)
of the multiplexer enable parameterization via the operator panel or the application VTable in VPlus.
Parameters
No. Description
1250 Mux Input Index (write)
1251 Mux Input Index (read)
1)
non-volatile (fixed parameterization):
0: All indices in EEPROM
1...16: One index in EEPROM
NOTE
Setting "0" for
In the case of non-volatile storage (0...16), the changed values are still available when
power supply is switched on again.
In the case of volatile storage (17...33), the data is only stored in RAM. If the unit is
switched off, this data is lost and the data required are loaded from EEPROM.
Demultiplexer:
1253 DeMux Input
The demultiplexer features an input
RxPDO of the system bus or OUT-PZDx of Profibus.
On the output of the demultiplexer, the logic signals "910 - Output DeMux Bit 0" to "925 - Output
DeMux Bit15" are available, e.g. for control of PLC-functions.
9 - Zero
704 ... 727 - RxPDO Word
740, 741 - Remote control word , remote state word
754 ... 757 - OUT-PZD word
900 - Controller status
927 - Output MUX
Demultiplexer outputs
910 ... 925 - Output DeMux Bit 0 ... output DeMux Bit 15
Agile
Operating Instructions
7 - Off
1250 and
Mux Input Index (read)
Min.
1)
0
0
Volatile:
17:
18...33: One index 1...16 in RAM
Mux Input Index (write)
DeMux Input
Operation modes for
206
06/2013
used.
Factory setting
1251 for the input signals
Setting
Max. Fact. sett.
33
33
All indices in RAM
1250 changes all data in EEPROM and RAM.
1253 whose signal can be for the process data
1253
DeMux input
Control inputs and outputs
Parameter descriptions
1
1