Input Pwm/Repetition Frequency/Pulse Train - BONFIGLIOLI Agile Operating Instructions Manual

Parameter descriptions
Example: Transfer of a user-defined status word from a slave to a master via system bus or Profibus,
parameterization of multiplexer and demultiplexer using PC application VTable in VPlus
Settings on transmitter:
• In VPlus, start application VTable via the button bar.
In VTable assign the required signal sources for sending to parameter
•
to index 16. A setting for index 0 results in this setting being taken over for all other indices.
• Assign signal source "927 – Output MUX" to a TxPDO process data parameter of the system bus
or a PZDx-IN process data parameter of Profibus.
Settings on receiver:
Assign the corresponding RxPDO signal sources of the system bus or OUT-PZD signal sources of
•
Profibus to parameter
The transmitted signals are available at the receiver as signal sources 910 to 925.
7.6.7

Input PWM/repetition frequency/pulse train

496 Operation Mode IN2D (PWM/repetition frequency/pulse train)
A PWM signal (pulse-width modulated signal), frequency signal or a pulse train (pulse sequence) sig-
nal can be used for definition of a reference value. The signal at digital input IN2D (at terminal X11.5)
is evaluated according to the selected
Operation Mode IN2D
0 - Off
10 - PWM, 0% – 100%
11 - PWM, -100% – 100%
20 - RF Single Evaluation
Control inputs and outputs
1253.
DeMux Input
Operation Mode IN2D
496
The PWM signal or repetition frequency is zero.
Factory setting.
PWM signal detection at digital input IN2D (at terminal X11.5).
0 ... 100% of
Maximum Reference Percentage
of
Maximum Frequency
PWM signal detection at digital input IN2D (at terminal X11.5).
-100 ... 100% of
-100 ... 100% of
input".
Repetition frequency input at digital input IN2D (at terminal
X11.5). One edge of the frequency signal is evaluated. The signal
can also be evaluated as a percentage. See 7.6.7.2 "Repetition
frequency input".
207
Mux. Inputs
496.
Function
419. See 7.6.7.1 "PWM input".
Maximum Reference Percentage
419. See 7.6.7.1 "PWM
Maximum Frequency
06/2013 Operating Instructions
1252 index 1
519 or 0 ... 100%
519 or
Agile