Warning Status And Warning Status Application - BONFIGLIOLI Agile Operating Instructions Manual

Code
C 00 10 Boost The
The output current is limited by the current limit value controller or the speed
C 00 20 Ilim
controller.
C 00 40 Tlim The output power or the torque is limited by the speed controller.
Switch-over of field-orientated control between speed and torque-controlled
C 00 80 Tctr
control method.
The
C 01 00 Rstp
rent
Overload limit of the long-term Ixt (60 s) reached, intelligent current limits
C 02 00 IxtLtLim
active
Overload limit of the short-term Ixt (1 s) reached, intelligent current limits
C 04 00 IxtStLim
active.
Max. heat sink temperature T
C 08 00 Tclim
Mode
Max. motor temperature T
C 10 00 PTClim
Mode
Reference frequency reached the
C 20 00 Flim
limitation is active.
Example:
The controller status is displayed:
C0024 UDctr Ilim
The controller status results from the hexadecimal sum of the controller codes (0004+0020 = 0024).
At the same, the power failure regulation and also the current limita-tion of the speed controller are
active.
14.3

Warning status and warning status application

The current warning is displayed by a message in the warning status and can be used for an early
message of a critical operational condition. Warnings are also displayed on the operator panel. If sev-
eral warnings are present, the warning status is displayed as the sum of the individual warning codes.
Via the actual value parameters
error environment) and
at the time of the error are displayed.
AXXXX
Warning code
The warning masks created through parameters
626 have no influence on the warnings displayed.
application
356 Warning Status
The parameter displays the warning at failure switch-off.
Meaning of code displayed by parameter
Code
A 00 00 - No warning message present.
A 00 01 Ixt Frequency inverter overloaded (A0002 or A0004)
A 00 02 IxtSt Overload for 60 s relative to the nominal output of the frequen-cy inverter
Short-time overload for 1 s relative to the nominal output of the frequency
A 00 04 IxtLt
inverter.
Agile
Operating Instructions
Dyn. Voltage Pre-Control
620 selected in starting behavior limits the output cur-
Operation Mode
573 active.
573 active.
269,
Warning
Application warning status
Coding of the warning status

Abbreviation for the warning
Warning Status
06/2013
Operational and error diagnosis
Controller status
605 accelerates the control characteristics.
reached, intelligent current limits of
K
reached, intelligent current limits of
PTC
Maximum Frequency
273,
Application Warnings
367 (in error environment), all warnings present
ABCDE

536 and
Create warning mask
356:
Warning status
336
Warning status and warning status application
Operation
Operation
419. The frequency
356 (in
Warning status
Create warning mask