BONFIGLIOLI Agile Operating Instructions Manual page 79

Commissioning
TCP/IP
Parameter
1432 Set up the IP address.
This is done in 4 steps. The dots mark the current position.
1433 Set up the Subnet mask.
This is done in 4 steps. The dots mark the current position.
1434 Set up the Gateway address.
This is done in 4 steps. The dots mark the current position.
1435 Set up the DNS server address.
This is done in 4 steps. The dots mark the current position.
1436 If a DHCP Server should and can be used, this setting is
used.
0 = Off/Disabled
1 = On/Enabled
When the DHCP is enabled, the above settings are not re-
quired.
APPLY: Must be used after the configuration of the above
settings. Only if the settings are applied, they are taken
over. If this was not successful, an error or timeout mes-
sage might occur.
RELOAD: Reload can be used to reload the default values. If
this was not successful, an error or timeout message might
occur.
Commissioning of a communication interface
79
06/2013 Operating Instructions
Display
Agile