Configuration Process On The Dp Master - BONFIGLIOLI ACTIVE Manual

7.1

Configuration process on the DP master

The configuration process of the frequency inverter with the Profibus communication
module CM-PDP is displayed here with the example of a Siemens STEP7 hardware
configurator. The process is principally valid for other configurations in an equivalent
form.
First, the GSD file VEC_0696.GSD is installed in the hardware configurator (if not al-
ready existent). This is done with the menu selection Extras \ Install new GSD.
Here, you enter the path and the name for the GSD file (VEC_0696.GSD).
If the GSD file has been installed, the frequency inverter appears under the selection
PROFIBUS-DP \ Further FIELD DEVICES \ Drives \ ACT 10
From this position, an ACT frequency inverter can now be connected to the required
Profibus phase by Drag & Drop.
The four possible objects PPO1 to PPO4 are now visible under the menu point
ACT 10. The required object is now assigned to the inverter by Drag & Drop.
The screen shot from the STEP7 hardware configuration shows an ACT frequency
inverter with the station address 3 and the object PPO2.
10 06/05
10 06/05