BONFIGLIOLI Agile Operating Instructions Manual page 337

Operational and error diagnosis
Code
Maximum heat sink temperature T
A 00 08 Tc
407 reached.
Maximum inside temperature T
A 00 10 Ti
reached.
A 00 20 Lim The controller stated in
A 00 40 INIT Frequency inverter is being initialized
Warning behavior according to parameterized
A 00 80 PTC
570 at maximum motor temperature T
A 01 00 Mains
Phase Supervision
A 02 00 PMS Motor circuit breaker parameterized in
The
A 04 00 Flim
tive.
The input signal MFI1A is lower than 1 V / 2 mA according to the operation
A 08 00 A1
mode for the
The input signal MFI2A is lower than 1 V / 2 mA according to the operation
A 10 00 A2
mode for the
A 20 00 SYS A slave on the system bus signals an error.
A 40 00 UDC The DC link voltage has reached the type-dependent minimum value.
A 80 00 WARN2 In
Example:
The following warning status is displayed:
A008D Ixt IxtLt Tc PTC
The warning status results from the hexadecimal sum of the warning codes (0001+0004+0008+0080
= 008D).
The short-term overload (1 s), warning limit heat sink temperature and warning limit motor tempera-
ture warnings are present.
Output signals
Warnings are signaled via digital signals.
169 - general warning
11 - General warning
1)
For linking to frequency inverter functions
2)
For output via a digital output. Select the signal source for one of the parameters 531, 532, 533,
554. See chapter 7.6.5 "Digital outputs".
Warning status and warning status application
Controller Status
576 reports a phase failure.
419 was exceeded. The frequency limitation is ac-
Maximum Frequency
Error/Warning Behaviour
Error/Warning Behaviour
Application Warning State
1)
Signal if a message is output via
2)
337
Warning status
minus the
Warning Limit Heat Sink Temp.
K
minus the
Warning Limit Inside Temp.
i
275 limits the reference value.
Operation Mode Motor Temp.
.
Motor
Operation Mode
453.
563.
367, a warning is present.
Warnings
06/2013 Operating Instructions
408
571 tripped.
269.
Agile