Start Command; 3-Wire Control - BONFIGLIOLI Agile Operating Instructions Manual

Signals via physical contacts (IN1D...IN5D, MFI1, MFI2) are only evaluated if an oper-
ation mode
5) is selected.
In all other operation modes
evaluated, if the corresponding signals in the digital inputs with the suffix (Hardware)
are selected.
Signals not referring to a physical input are evaluated independent of the operation
mode
Local/Remote
7.6.6.2

Start command

68 Start Clockwise
69 Start Anticlockwise
The parameters
Start Clockwise
control inputs or the internal logic signals. The drive is only accelerated according to the control
method after a start command.
The logic functions are used for the specification of the direction of rotation, but also for using the
parameterized
Operation Mode
ping behavior.
Parameter
68
Start Clockwise
69
Start Anticlockwise
7.6.6.3

3-Wire Control

87 Start 3-Wire Ctrl
In the case of 3-wire control, the drive is controlled using digital pulses. The drive is prepared for
starting via the logic state of the signal
(Parameter
Start Clockwise
switching off the signal
Start 3-Wire Ctrl
The control signals for Start clockwise and Start anticlockwise are pulses. The functions Start clock-
wise and Start anticlockwise for the drive are latching-type functions when signal
is switched on. Latching is cancelled when the latching signal is switched off.
Drive
Start Clockwise
Start Anticlockwise
Start 3-Wire-
Ctrl
(C) Clockwise
(A) Anticlockwise
The drive is started according to the configured starting behavior if the signal
switched on and a positive signal edge for Start clockwise or Start anticlockwise is detected.
Once the drive has started, new edges (1) on the start signals will be ignored.
If the start signal is shorter than 32 ms (2) or if both start signals were switched on within 32 ms (2),
the drive will be switched off according to the configured stopping behavior.
Agile
Operating Instructions
412 with "Control via Contact" or "Control 3-Wire" (0, 4 or
Local/Remote
Local/Remote
412.
68 and
Start Anticlockwise
620 for the starting behavior and
Factory setting
71 – IN1D
72 – IN2D
Start 3-Wire Ctrl
68) or a start anticlockwise pulse (parameter
87, the drive is stopped.
C
A
1
(1) Signals are ignored
(2) Time t < 32 ms
200
06/2013
Parameter descriptions
412 (1, 2, 3) physical contacts are only
69 can be linked to the available digital
Operation Mode
87 and started by a Start clockwise pulse
Start Anticlockwise
Start 3-Wire Ctrl
C
2
Start 3-Wire Ctrl
Control inputs and outputs
630 for the stop-
69). By
87
t
87 is