Emptying The Punch Waste Container (For Finisher-B1) - Fuji Xerox ApeosPort-III C2201 Administrator's Manual

5
Lift the staple cartridge out of the unit.
6
Hold the tabs on both sides of the new staple
cartridge, and insert it into the original posi-
tion until it clicks.
7
Push the staple cartridge unit into its original
position.
8
Close the front cover of the finisher.
Note • If the front cover of the finisher is not completely closed, a message will appear and the

Emptying the Punch Waste Container (for Finisher-B1)

When the hole punch waste container becomes full, a message appears on the touch
screen. When the message is displayed, empty the hole punch waste container as
instructed.
Make sure to discard all paper chads when emptying the hole punch waste container.
If you do not empty the container completely, the container becomes full before the
message stating to empty the container appears again, and this can cause a
breakdown of the machine.
Important • Make sure you empty the hole punch waste container when the power is on. If you empty
1
Make sure that the machine is not operating,
lift the top cover and open the front transport
cover of the finisher.
machine will not operate.
the container when the power is off, the machine will not recognize that the container has
been emptied.
Replacing Consumables
65
3