H3C S3100 Series Command Manual page 1004

Hide thumbs Also See for S3100 Series:

Table of Contents

With routing table bypass, a remote host can bypass the normal routing tables and send ICMP packets

directly to a host on an attached network. If the host is not on a directly connected network, an error is

returned. You can use this function when pinging a local host on an interface that has no route defined.

# Bypass routing table when sending ICMP packets.

<Sysname> system-view

System View: return to User View with Ctrl+Z

[Sysname] hwping administrator icmp

[Sysname-hwping-administrator-icmp] sendpacket passroute

source-interface

source-interface interface-type interface-number

undo source-interface

HWPing test group view

interface-type interface-number: Interface type and interface number.

For ICMP tests, use the source-interface command to specify a source interface for sending ICMP

requests. The corresponding IP address of the specified interface is used as the source IP address of

ICMP requests. For DHCP tests, use the source-interface command to specify an interface for DHCP

For ICMP tests, use the undo source-interface command to remove the specified source interface,

and its corresponding IP address is no longer used as the source IP address of ICMP requests. For

DHCP tests, use the undo source-interface command to remove the specified interface for DHCP

By default, no source interface is specified for ICMP tests and no interface is configured for DHCP

For DHCP tests, this command is required. For ICMP tests, this command is optional. This

command does not apply to other tests.

For ICMP tests, if a source IP address has been configured with the source-ip command, the

source-interface command cannot change the configured IP address.

For an ICMP test, if a source interface has been configured with the source-interface command,

the test destination address should be configured as the address of the device directly connected

to the interface. Otherwise, the test will fail.

The interface to be specified in this command can be only a VLAN interface.

The interface to be specified must be Up; otherwise the test will fail.

Chapters

Table of Contents