H3C S3100 Series Command Manual page 915

Hide thumbs Also See for S3100 Series:

Table of Contents

After you separately set the output rules for a module, you must use the module-name argument to

modify or remove the rules. The new configuration by using the default keyword is invalid on the

You can configure to output the log, trap and debugging information to the trap buffer, but the trap

buffer only receives the trap information and discards the log and debugging information.

You can configure to output the log, trap and debugging information to the log buffer, but the log

buffer only receives the log and debugging information and discards the trap information.

You can configure to output the log, trap and debugging information to the SNMP module, but the

SNMP module only receives the trap information and discards the log and debugging information.

Table 1-4 Default output rules for different output destinations

default (all

default (all

default (all

default (all

default (all

default (all

default (all

# Set the output channel for the log information of VLAN module to snmpagent and to output

information with severity being emergencies. Log information of other modules cannot be output to this

<Sysname> system-view

[Sysname] info-center source default channel snmpagent log state off

[Sysname] info-center source vlan channel snmpagent log level emergencies state on

# Set the output channel for the log information of VLAN module to snmpagent and to output

information with severity being emergencies. Log information of other modules and all the other

system information cannot be output to this channel.

<Sysname> system-view

[Sysname] info-center source default channel snmpagent debug state off log state off trap

[Sysname] info-center source vlan channel snmpagent log level emergencies state on

Chapters

Table of Contents