Stack Function Configuration Commands; Display Stacking - H3C S3100 Series Command Manual

Hide thumbs Also See for S3100 Series:

Table of Contents

Stack Function Configuration Commands

display stacking [ members ]

members: Displays the information about the members of a stack. Do not specify this keyword when

you execute this command on a slave switch.

Use the display stacking command to display the information about the main switch or the slave

switches of a stack.

When you execute this command on a main switch, the information displayed depends on the

members keyword as follows:

If the members keyword is not specified, the output information indicates that the local switch is the

main switch. Besides, the number of the switches contained in the stack is also displayed.

If the members keyword is specified, the information about the members of the stack is displayed,

including the stack numbers of the main/slave switches, stack name, stack device name, MAC

address and status.

When you execute this command on a slave switch, the information displayed indicates that the local

switch is a slave switch. Besides, the information such as the stack number of the local switch, and the

MAC address of the main switch in the stack is also displayed.

# Display the information about a stack on the main switch.

<stack_0.Sysname>display stacking

Main device for stack.

Total members:3

Management-vlan:1(default vlan)

# Display the information about the stack members on the main switch.

<stack_0.Sysname> display stacking members

Member number: 0

Name:stack_0.Sysname

Device: S3100

Table of Contents