H3C S3100 Series Command Manual page 1192

Field
Relay Action
display cfd ma
Syntax
display cfd ma [ [ ma-name ] md md-name ]
View
Any view
Default Level
2: System level
Parameters
ma-name: Name of MA, ranging from 1 to 43 characters, composed of letters, numbers or underlines,
but cannot start with an underline character.
md md-name: Specifies the name of an MD, ranging from 1 to 43 characters, composed of letters,
numbers or underlines, but cannot start with an underline character.
Description
Use the display cfd ma command to display the configuration of a specified MA.
Note that:
If MD is not specified, this command will display the MA configurations of all MDs on the device.
If both MD and MA are specified, this command will display the specified MA configuration.
If only MD is specified, this command will display the configurations of all MAs in that MD.
Examples
# Display the MA configuration information in all MDs.
<Sysname> display cfd ma
3 maintenance domain(s) configured.
Maintenance domain: mdtest_5
1 maintenance association(s) belong(s) to maintenance domain mdtest_5:
Maintenance association: matest_5
Service instance: 5
Maintenance domain: mdtest_6
Indicates whether the forwarding device found the destination MAC address in its
MAC address table.
When the standard version of IEEE 802.1ag is used:
Hit: Indicates that the current device is the destination device.
FDB: Indicates that the forwarding device found the destination MAC address.
MPDB: Indicates that the destination MAC address is not found, or that the
destination MAC address is found in the MEP or MIP database.
When IEEE 802.1ag draft5.2 or the IEEE 802.1ag draft5.2 interim version is used:
Found: Indicates that the forwarding device found the destination MAC
address.
Unknown: Indicates that the forwarding device failed to find the destination
MAC address.
None: Indicates that it is a MEP that responded to the LTM message. A MEP
does not need to find the destination MAC address.
VLAN: 5
1-17
Description
Level: 5