H3C S3100 Series Command Manual page 1197

display cfd mp
Syntax
display cfd mp [ interface interface-type interface-number ]
View
Any view
Default Level
1: Monitor level
Parameters
interface interface-type interface-number: Displays the MP information on a port specified by its port
type and port number.
Description
Use the display cfd mp command to display the MP information.
Note that:
If no port is specified, this command displays the MP information on all ports.
The information displayed is sorted by port name primarily in the ascending VLAN ID order within
the same port, and in the order of outward-facing MEPs (from low to high level), MIPs, and
inward-facing MEPs (from high to low level) within the same VLAN.
Examples
# Display the MP information on all ports.
<Sysname> display cfd mp
Interface Ethernet1/0/1
MEP ID: 100
Maintenance domain: mdtest0
Maintenance association: mainmd0
MEP ID: 105
Maintenance domain: mdtest5
Maintenance association: mainmd5
MIP
Maintenance domain: mdtest6
Maintenance association: mainmd6
MEP ID: 104
Maintenance domain: mdtest4
Maintenance association: mainmd4
MEP ID: 102
Maintenance domain: mdtest2
Maintenance association: mainmd2
Interface Ethernet1/0/4
MEP ID: 9
Maintenance domain: mdtest6
VLAN 100
Level: 0 Service instance: 100
Level: 5 Service instance: 105
Level: 6 Service instance: 106
Level: 4 Service instance: 104
Level: 2 Service instance: 102
VLAN 1
Level: 6 Service instance: 6
Direction: Outbound
Direction: Outbound
Direction: Inbound
Direction: Inbound
Direction: Outbound
1-22