Bpdu Tunnel Configuration Commands - H3C S3100 Series Command Manual

3

BPDU Tunnel Configuration Commands

This chapter is only applicable to the S3100-EI series Ethernet switches.
BPDU Tunnel Configuration Commands
bpdu-tunnel
Syntax
bpdu-tunnel protocol-type
undo bpdu-tunnel { protocol-type | all }
View
Ethernet port view
Parameters
protocol-type: Protocol type, packets of which will be transmitted through a BPDU tunnel, This
argument can be a keyword listed in
Table 3-1 Description on the protocol-name argument
cdp
hgmp
lacp
pagp
pvst
stp
Table 3-1.
Value
Enable/Disable BPDU tunnel for CISCO
discovery protocol (CDP).
Enable/Disable BPDU tunnel for Huawei group
management protocol (HGMP) related protocols,
including neighbor discovery protocol (NDP),
neighbor topology discovery protocol, cluster
member remote control (MRC), and Huawei
authentication bypass protocol (HABP).
Enable/Disable BPDU tunnel for link aggregation
control protocol (LACP).
Enable/Disable BPDU tunnel for port
aggregation protocol (PAGP).
Enable/Disable BPDU tunnel for per-VLAN
spanning tree (PVST).
Enable/Disable BPDU tunnel for spanning tree
protocol (STP).
3-1
Description