H3C S3100 Series Command Manual page 1008

The test starts until you execute the test-time begin command.
If you set a start time earlier than the current system time, when you modify the current system time,
the test will not be performed.
If lifetime of the test group expires, the test will stop and when you modify the current system time,
the test will not be performed.
Examples
# Set the test to start from 14:03 and last 3600 seconds.
<Sysname> system-view
System View: return to User View with Ctrl+Z
[Sysname] hwping administrator icmp
[Sysname-hwping-administrator-icmp] test-time begin 14:03:00 lifetime 3600
test-type
Syntax
test-type type [ codec codec-value ]
View
HWPing test group view
Parameters
type: Test type. It can be any of the following keywords:
dhcp: Indicates a DHCP test.
dns: Indicates a DNS test.
ftp: Indicates an FTP test.
http: Indicates an HTTP test.
icmp: Indicates an ICMP test.
jitter: Analyzes the delay change of UDP packet transmission.
snmpquery: Indicates an SNMP test.
tcpprivate: Indicates a TCP test on a specified (unknown) port.
tcppublic: Indicates a TCP test on port 7.
udpprivate: Indicates a UDP test on a specified (unknown) port.
udppublic: Indicates a UDP test on port 7.
codec-value: Coding type for a voice test, which can be configured for a Jitter test and can be the
following keywords:
g711a: Specifies coding type to G.711 A-Law.
g711u: Specifies coding type to G.711 muHmm-Law.
g729a: Specifies coding type to G.729A-Law.
Description
Use the test-type command to configure the test type.
The default test type is icmp.
1-29