Reboot; Schedule Reboot At - H3C S3100 Series Command Manual

Hide thumbs Also See for S3100 Series:

Table of Contents

reboot

reboot [ unit unit-id ]

unit-id: Unit ID of a switch, the value can only be 1.

Use the reboot command to restart a specified Ethernet switch.

Before rebooting, the system checks whether there is any configuration change. If yes, it prompts

whether or not to proceed. This prevents the system from losing the configurations in case of shutting

down the system without saving the configurations.

# Directly restart this switch without saving the current configuration.

<Sysname> reboot

Start to check configuration with next startup configuration file,

please wait......

This command will reboot the device. Current configuration may be lost in next startup if

you continue.

This will reboot device. Continue? [Y/N] y

2 00:06:01:148 2006 Sysname DEV/5/DEV_LOG:- 1 -

Switch is rebooting...

Starting......

schedule reboot at hh:mm [ mm/dd/yyyy | yyyy/mm/dd ]

undo schedule reboot

hh:mm: Reboot time, where hh (hour) ranges from 0 to 23, and mm (minute) ranges from 0 to 59.

Continue? [Y/N] y

Table of Contents