H3C S3100 Series Command Manual page 985

jitter: Displays the jitter test information.
administrator-name: Name of the administrator who created the HWPing test operation, a string of 1 to
32 characters.
operation-tag: Operation tag, a string of 1 to 32 characters.
Description
Use the display hwping command to display the result of the last HWPing test or the history of
HWPing tests.
Without administrator-name test-operation-tag specified, the command displays the results of all test
groups; without administrator-name test-operation-tag specified, the command displays the results of
the specified test group.
Related commands: test-enable.
Examples
# Display the test results of the test group with administrator name administrator, and operation tag
icmp.
<Sysname> display hwping results administrator icmp
HWPing entry(admin administrator, tag icmp) test result:
Destination ip address:10.2.2.2
Send operation times: 10
Min/Max/Average Round Trip Time: 1/2/1
Square-Sum of Round Trip Time: 13
Last succeeded test time: 2004-11-25 16:28:55.0
Extend result:
SD Maximal delay: 0
Packet lost in test: 0%
Disconnect operation number: 0
System busy operation number: 0
Operation sequence errors: 0
Other operation errors: 0
Table 1-3 Description on the fields of the display hwping result command
Destination ip address
Send operation times
Receive response times
Min/Max/Average Round Trip Time
Square-Sum of Round Trip Time
Last succeeded test time
SD Maximal delay
DS Maximal delay
Packet lost in test
Disconnect operation number
System busy operation number
Operation sequence errors
Field
1-6
Receive response times: 10
DS Maximal delay: 0
Operation timeout number: 0
Connection fail number: 0
Drop operation number: 0
Description
Destination IP address
Number of probes made
Number of received response packets
Minimum/maximum/average roundtrip time, in
milliseconds
Square sum of roundtrip time
Completion time of the last successful test
Maximum delay from the source to the destination
Maximum delay from the destination to the source
Average packet loss ratio
Number of times the test was disconnected by the
remote end
Number of times the test failed because the system
was busy
Number of out-of-sequence packets received