H3C S3100 Series Command Manual page 1103

Description
Use the display lldp status command to display the LLDP status of a port.
If no port is specified, this command displays the LLDP status of all the ports.
Examples
# Display the LLDP status of all the ports.
<Sysname> display lldp status
Global status of LLDP: Enable
The current number of LLDP neighbors: 2
The current number of CDP neighbors: 0
LLDP neighbor information last changed time: 0 days,0 hours,4 minutes,40 seconds
Transmit interval
Hold multiplier
Reinit delay
Transmit delay
Trap interval
Fast start times
Port 1 [Ethernet1/0/1]:
Port status of LLDP
Admin status
Trap flag
Roll time
Number of neighbors:
Number of MED neighbors
Number of CDP neighbors
Number of sent optional TLV
Number of received unknown TLV : 5
Table 1-4 display lldp status command output description
Field
Global status of LLDP
The current number of LLDP
neighbors
The current number of CDP
neighbors
LLDP neighbor information last
changed time
Transmit interval
Hold multiplier
Reinit delay
Transmit delay
Trap interval
: 30s
: 4
: 2s
: 2s
: 5s
: 3
: Enable
: Tx_Rx
: No
: 0s
5
: 2
: 0
: 12
Indicating whether or not LLDP is globally enabled
Total number of the LLDP neighbor devices
The current number of CDP neighbors
Time the neighbor information is latest updated
Interval to send LLDPDU
TTL multiplier
Initialization delay
Delay period to send LLDPDUs
Interval to send traps
1-11
Description