Mld-Snooping General-Query Source - H3C S3100 Series Command Manual

Note that:
This command works on MLD snooping–enabled VLANs.
If you do not specify any VLAN when using this command in Ethernet interface view, the command
will take effect for all VLANs the interface belongs to; if you specify a VLAN or multiple VLANs, the
command will take effect only if the interface belongs to the specified VLAN(s).
Related commands: fast-leave.
Examples
# Enable fast leave processing on Ethernet 1/0/1 in VLAN 2.
<Sysname> system-view
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1] mld-snooping fast-leave vlan 2
mld-snooping general-query source-ip
Syntax
mld-snooping general-query source-ip { ipv6-address | current-interface }
undo mld-snooping general-query source-ip
View
VLAN view
Default Level
2: System level
Parameters
ipv6-address: Specifies the source IPv6 address of MLD general queries, which can be any legal IPv6
link-local address.
current-interface: Sets the source IPv6 link-local address of MLD general queries to the IPv6 address
of the current VLAN interface. If the current VLAN interface does not have an IPv6 address, the default
IPv6 address FE80::02FF:FFFF:FE00:0001 will be used as the source IPv6 address of MLD general
queries.
Description
Use the mld-snooping general-query source-ip command to configure the source IPv6 address of
MLD general queries.
Use the undo mld-snooping general-query source-ip command to restore the default configuration.
By default, the source IPv6 address of MLD general queries is FE80::02FF:FFFF:FE00:0001.
This command takes effect only if MLD snooping is enabled in the VLAN.
Related commands: mld-snooping enable.
Examples
# In VLAN 2, enable MLD snooping and specify FE80:0:0:1::1 as the source IPv6 address of MLD
general queries.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
2-11