Web-Authentication Timer Idle-Cut - H3C S3100 Series Command Manual

Extended: In this method, a hybrid port allows multiple Web authentication users to get online at
the same time.
This configuration takes effect only when Web authentication is enabled globally. If Web authentication
is not enabled globally, this configuration will only be saved.
It is not allowed to enable Web authentication on a port in an aggregation group.
Examples
# Enable Web authentication on Ethernet 1/0/1 and set the Web authentication access method to
shared.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1] web-authentication select method shared

web-authentication timer idle-cut

Syntax
web-authentication timer idle-cut timer
undo web-authentication timer idle-cut
View
System view
Parameters
timer: Interval for checking whether an online user is idle. It ranges from 10 to 86400 seconds. Value 0
means the idle user checking function is disabled.
Description
Use the web-authentication timer idle-cut command to set the idle user checking interval for Web
authentication.
Use the undo web-authentication timer idle-cut command to restore the default.
By default, the idle user checking interval is 900 seconds for Web authentication.
The idle user checking interval is the interval at which the system checks whether a user is idle. When a
user is found idle, if the corresponding MAC address entry has not been aged out, the system keeps the
user online; otherwise, the system logs off the user. You are recommended to set the interval to a value
that is greater than half of the MAC address entry aging time but less than the MAC address entry aging
time.
1-11