H3C S3100 Series Command Manual page 1006

Parameters
port-number: Protocol source port number, in the range of 1 to 50000.
Description
Use the source-port command to configure the protocol source port number for the current test.
Use the undo source-port command to remove the configured source port number.
This command does not apply to ICMP, DHCP, and DNS tests.
Examples
# Configure the source port number as 8000 for the tcpprivate test.
<Sysname> system-view
System View: return to User View with Ctrl+Z
[Sysname] hwping administrator tcpprivate
[Sysname-hwping-administrator-tcpprivate] test-type tcpprivate
[Sysname-hwping-administrator-tcpprivate] source-port 8000
statistics
Syntax
statistics { interval interval | max-group number }
undo statistics { interval | max-group }
View
HWPing test group view
Parameters
interval: Statistics interval, in the range 1 to 1440, in minutes, and defaults to 60 minutes.
number: Number of groups of statistics information, in the range 1 to 100 and defaults to 2.
Description
Use the statistics command to configure the statistics interval and the maximum number of the groups
of the retained statistics information according to the configuration.
Use the undo statistics command to remove your configuration and restore the default.
By default, the statistics interval for a test is once every 60 minutes and up to two groups of statistics
information can be retained.
Delete all statistics information when internet parameter changes.
Examples
# Set the statistics interval to 120 minutes and the maximum number of statistics groups to three.
<Sysname> system-view
System View: return to User View with Ctrl+Z
[Sysname] hwping administrator icmp
[Sysname-hwping-administrator-icmp] statistic interval 120
[Sysname-hwping-administrator-icmp] statistic max-group 3
1-27