H3C S3100 Series Command Manual page 745

View
Any view
Parameter
None
Description
Use the display poe powersupply command to view the parameters of the power sourcing equipment
(PSE).
Example
# Display the PSE parameters.
<Sysname> display poe powersupply
Unit 1
PSE ID
PSE Legacy Detection
PSE Total Power Consumption :0 mW
PSE Available Power
PSE Peak Value
PSE Average Value
PSE Software Version
PSE Hardware Version
PSE CPLD Version
PSE Power-Management mode
Table 1-3 Description on the fields of the display poe powersupply command
PSE ID
PSE Legacy Detection
PSE Total Power Consumption
PSE Available Power
Power Peak Value
Power Average Value
Power Software Version
Power Hardware Version
PSE CPLD Version
PSE Power-Management mode
:0
:disable
:128000 mW
:0 mW
:0 mW
:501
:000
:001
:auto
Field
Identification of the PSE
The enabled/disabled status of the nonstandard PD detection
Total power consumption of the PSE
Available power of the PSE
Peak power value of the PSE
Average power value of the PSE
Version of the PSE software
Version of the PSE hardware
Version of the PSE complex programmable logical device
(CPLD)
PoE management mode on the port when the PSE is
overloaded:
The auto keyword indicates that the auto mode is adopted, that
is, the PoE management mode based on the PoE priority of the
port is adopted
The manual keyword indicates that the manual mode is adopted
in the PoE management on the port
1-4
Description