Attribute - H3C S3100 Series Command Manual

The accounting optional command is commonly used in the cases where only authentication is
needed and accounting is not needed.
If you configure the accounting optional command in ISP domain view, it is effective to all users in
the domain; if you configure it in RADIUS scheme view, it is effective to users the RADIUS scheme
is used for.
Examples
# Open the accounting-optional switch for the ISP domain named aabbcc.net.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] domain aabbcc.net
New Domain added.
[Sysname-isp-aabbcc.net] accounting optional

attribute

Syntax
attribute { ip ip-address | mac mac-address | idle-cut second | access-limit max-user-number | vlan
vlan-id | location { nas-ip ip-address port port-number | port port-number } }*
undo attribute { ip | mac | idle-cut | access-limit | vlan | location }*
View
Local user view
Parameters
ip ip-address: Sets the IP address of the user.
mac mac-address: Sets the MAC address of the user. Here, mac-address is in H-H-H format.
idle-cut second: Enables the idle-cut function for the local user and sets the allowed idle time. Here,
second is the allowed idle time, which ranges from 60 to 7,200 seconds.
access-limit max-user-number: Sets the maximum number of users who can access the switch with
the current username. Here, max-user-number ranges from 1 to 1,024.
vlan vlan-id: Sets the VLAN attribute of the user (that is, specifies to which VLAN the user belongs).
Here, vlan-id is an integer ranging from 1 to 4094.
location: Sets the port binding attribute of the user.
nas-ip ip-address: Sets the IP address of an access server, so that the user can be bound to a port on
the server. Here, ip-address is in dotted decimal notation and is 127.0.0.1 by default (representing this
device). When binding the user to a remote port, you must use nas-ip ip-address to specify a remote
access server IP address. When binding the user to a local port, you need not use nas-ip ip-address.
port port-number: Sets the port to which you want to bind the user. Here, port-number is in the format of
device ID/slot number/port number; the device ID ranges from 1 to 8, the slot number ranges from 0 to
15 (if the bound port has no slot number, just input 0 for this item) and the port number ranges from 1 to
255.
Description
Use the attribute command to set the attributes of a user whose service type is lan-access.
1-5