Dhcp-Snooping Ipv6 Max-Learning-Num - H3C S3100 Series Command Manual

View
System view
Parameters
ipv4-address ipv4-address: Specifies an IPv4 address for the DHCPv6 sub-option.
ipv6-address ipv6-address: Specifies an IPv6 address for the DHCPv6 sub-option.
string string: Customizes the DHCPv6 sub-option with a string of 1 to 63 characters.
sysname: Specifies the device name for the DHCPv6 sub-option.
Description
Use the dhcp-snooping ipv6 information remote-id command to configure the DHCPv6 sub-option.
Use the undo dhcp-snooping ipv6 information remote-id command to restore the default.
By default, the DHCPv6 sub-option is not configured.
Among the S3100 series Ethernet switches, only the S3100-EI series support this command.
Examples
# Specify the device name for DHCPv6 sub-option.
<Sysname> system-view
[Sysname] dhcp-snooping ipv6 information remote-id sysname

dhcp-snooping ipv6 max-learning-num

Syntax
dhcp-snooping ipv6 max-learning-num number
undo dhcp-snooping ipv6 max-learning-num
View
Layer 2 Ethernet interface view
Parameters
number: Maximum number of DHCPv6 snooping entries that can be learned by the interface, in the
range of 0 to 1023.
Description
Use the dhcp-snooping ipv6 max-learning-num command to configure the maximum number of
DHCPv6 snooping entries that can be learned on the interface.
Use the undo dhcp-snooping ipv6 max-learning-num command to restore the default.
By default, the number of DHCPv6 snooping entries that an interface can learn is not limited.
Among S3100 series switches, only S3100-EI series switches support the two commands.
1-3