Dot1X Port-Control - H3C S3100 Series Command Manual

Related command: display dot1x.
Example
# Configure the maximum number of users that Ethernet1/01 port can accommodate to be 32.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] dot1x max-user 32 interface Ethernet 1/0/1

dot1x port-control

Syntax
dot1x port-control { auto | authorized-force | unauthorized-force } [ interface interface-list ]
undo dot1x port-control [ interface interface-list ]
View
System view, Ethernet port view
Parameter
auto: Specifies to operate in auto access control mode. When a port operates in this mode, all the
unauthenticated hosts connected to it are unauthorized. In this case, only EAPoL packets can be
exchanged between the switch and the hosts. And the hosts connected to the port are authorized to
access the network resources after the hosts pass the authentication. Normally, a port operates in this
mode.
authorized-force: Specifies to operate in authorized-force access control mode. When a port
operates in this mode, all the hosts connected to it can access the network resources without being
authenticated.
unauthorized-force: Specifies to operate in unauthorized-force access control mode. When a port
operates in this mode, the hosts connected to it cannot access the network resources.
interface-list: Ethernet port list, in the form of interface-list= { interface-type interface-number [ to
interface-type interface-number ] } &<1-10>, in which interface-type specifies the type of an Ethernet
port and interface-number is the number of the port. The string "&<1-10>" means that up to 10 port lists
can be provided.
Description
Use the dot1x port-control command to specify the access control mode for specified Ethernet ports.
Use the undo dot1x port-control command to revert to the default access control mode.
The default access control mode is auto.
Use the dot1x port-control command to configure the access control mode for specified
802.1x-enabled ports.
In system view:
If you do not provide the interface-list argument, these two commands apply to all the ports of the
switch.
If you specify the interface-list argument, these commands apply to the specified ports.
In Ethernet port view, the interface-list argument is not available and the commands apply to only the
current Ethernet port.
1-12