System Debugging Commands; Debugging - H3C S3100 Series Command Manual

64M bytes SDRAM
8M bytes Flash Memory
Config Register points to FLASH
Hardware Version is REV.A
Bootrom Version is 506
CPLD Version is 001
[Subslot 0] 24FE
[Subslot 1]
[Subslot 2]

System Debugging Commands

debugging

Syntax
debugging module-name [ debugging-option ]
undo debugging { all | module-name [ debugging-option ] }
View
User view
Parameter
module-name: Module name.
debugging-option: Debugging option.
all: Specifies to disable all debugging.
Description
Use the debugging command to enable system debugging.
Use the undo debugging command to disable system debugging.
By default, all debugging is disabled for the system.
Note that:
Enabled debugging will generate a great deal of debugging information and thus will affect the
efficiency of the system. Therefore, it is recommended not to enable debugging for multiple
functions at the same time. To disable all debugging at a time, you can use the undo debugging
all command.
The specific debugging information can be displayed on a terminal only after you have configured
the debugging, terminal debugging, and terminal monitor commands.
To display the enabled debugging types, use the display debugging command.
For information about the terminal monitor command, refer to Information Center Command.
Example
# Enable IP packet debugging of the IP module.
<Sysname> debugging ip packet
<Sysname> display debugging
IP packet debugging is on
Hardware Version is REV.A
1GE Hardware Version is REV.A
1GE Hardware Version is REV.A
1-7