H3C S3100 Series Command Manual page 291

<Sysname> display igmp-snooping configuration
Enable IGMP Snooping.
The router port timeout is 105 second(s).
The max response timeout is 10 second(s).
The host port timeout is 260 second(s).
The above-mentioned information shows: IGMP Snooping is enabled, the aging time of the router port
is 105 seconds, the maximum response time in IGMP queries is 10 seconds, and the aging time of
multicast member ports is 260 seconds.
display igmp-snooping group
Syntax
display igmp-snooping group [ vlan vlan-id ]
View
Any view
Parameters
vlan vlan-id: Specifies the VLAN in which the multicast group information is to be displayed, where
vlan-id ranges from 1 to 4094.. If you do not specify a VLAN, this command displays the multicast group
information of all VLANs.
Description
Use the display igmp-snooping group command to display the IGMP Snooping multicast group
information.
Related commands: igmp-snooping, igmp host-join, multicast static-group interface, multicast
static-group vlan, multicast static-router-port, multicast static-router-port vlan
Examples
# Display the information about the multicast groups in VLAN 100.
<Sysname> display igmp-snooping group vlan 100
Total 1 IP Group(s).
Total 1 MAC Group(s).
Vlan(id):100.
Total 1 IP Group(s).
Total 1 MAC Group(s).
Static Router port(s):
Dynamic Router port(s):
IP group(s):the following ip group(s) match to one mac group.
IP group address:228.0.0.1
Static host port(s):
Dynamic host port(s):
MAC group(s):
MAC group address:0100-5e00-0001
Host port(s):Ethernet1/0/10
Ethernet1/0/11
Ethernet1/0/22
Ethernet1/0/23
Ethernet1/0/10
Ethernet1/0/23
1-2