Accounting Start-Mode; Accounting-On Enable - H3C S3100 Series Command Manual

Hide thumbs Also See for S3100 Series:

Table of Contents

accounting start-mode

accounting start-mode { with-ip | without-ip }

RADIUS scheme view

with-ip: Specifies the mode in which the device must obtain the IP address of a requesting client and

add the IP address to an accounting start request before this request can be sent to the RADIUS server.

without-ip: Specifies the mode in which the device sends the RADIUS server an accounting start

request without the IP address of the requesting client.

Use the accounting start-mode command to configure the sending mode of accounting start requests

in a RADIUS scheme.

In with-ip mode, the device must obtain the IP address of the requesting client and add the IP

address to an accounting start request before this request can be sent to the RADIUS server. If the

device fails to obtain the client's IP address 60 seconds after the client gets online, it logs the client

In without-ip mode, the device sends the RADIUS server an accounting start request without the

IP address of the requesting client. The client is allowed to be online even though the device cannot

obtain the client's IP address.

By default, the sending mode of accounting start requests in a RADIUS scheme is without-ip.

# Configure the sending mode of accounting start requests as with-ip for the RADIUS scheme named

<Sysname> system-view

[Sysname] radius scheme radius1

[Sysname-radius-radius1] accounting start-mode with-ip

accounting-on enable [ send times | interval interval ]

undo accounting-on { enable | send | interval }

RADIUS scheme view

times: Maximum number of attempts to send an Accounting-On message, ranging from 1 to 256 and

defaulting to 15. If the maximum number has been reached but the switch still receives no response

from the CAMS, the switch stops sending Accounting-On messages.

Table of Contents