System-Guard Permit - H3C S3100 Series Command Manual

View
System view
Parameter
None
Description
Use the system-guard enable command to enable the system-guard feature.
Use the undo system-guard enable command to disable the system-guard feature.
By default, the system-guard feature is disabled.
Related command: display system-guard state.
Example
# Enable the system-guard feature.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname]system-guard enable
System-guard is enabled

system-guard permit

Syntax
system-guard permit interface-list
undo system-guard permit interface-list
View
System view
Parameter
permit: Specifies the ports to which with the system-guard function is to be applied.
interface-list: Specifies an Ethernet port list, which can contain multiple Ethernet ports. The interface-list
argument is in the format of interface-list = { interface-type interface-number [ to interface-type
interface-number ] } & <1-10>, where interface-type represents the port type, interface-number
represents the port number, and & <1-10> means that you can provide up to 10 port indexes/port index
lists for this argument. The start port number must be smaller than the end number and the two ports
must of the same type.
Description
Use the system-guard permit command to specify the ports to which the system-guard function is to
be applied to. A switch checks the ports with the system-guard function applied regularly for attacked
ports.
Use the undo system-guard permit command to disable the system-guard function for specified ports.
By default, the system-guard function is disabled on a port.
4-4