H3C S3100 Series Command Manual page 354

Hide thumbs Also See for S3100 Series:

Table of Contents

QoS profile view

Default Level

2: System level

acl6-number: Basic or advanced IPv6 ACL number, in the range of 2000 to 3999. The source address or

address range specified in the advanced ACL is used to match the multicast source address(es)

specified in MLDv2 reports, rather than the source address in the IP packets. The system assumes that

an MLDv1 report or an MLDv2 IS_EX and TO_EX report that does not carry an IPv6 multicast source

address carries an IPv6 multicast source address of 0::0.

all: Specifies all IPv6 ACLs.

Use the mld-snooping access-policy command to configure an IPv6 multicast user control policy.

Use the undo mld-snooping access-policy command to remove the configuration.

By default, no IPv6 user control policy is configured, namely a user can join any valid IPv6 multicast

Note that you can execute this command repeatedly to configure multiple IPv6 multicast user control

# Create and enable a QoS profile named abc, and configure the QoS profile so that users in this QoS

profile can join FF03::101 only.

<Sysname> system-view

[Sysname] acl ipv6 number 2001

[Sysname-acl6-basic-2001] rule permit source ff03::101 16

[Sysname-acl6-basic-2001] quit

[Sysname] qos-profile abc

[Sysname-qos-profile-abc] mld-snooping access-policy 2001

[Sysname-qos-profile-abc] quit

Chapters

Table of Contents