Display Cfd Linktrace-Reply - H3C S3100 Series Command Manual

When deleting a service instance, you are deleting the configurations related to that service
instance as well.
Deleting a service instance simply breaks up the connection between the service instance and the
corresponding MA, the MA itself is not deleted.
Related commands: cfd md, cfd ma.
Examples
# Create a level-3 MD named test_md, create an MA named test_ma, which serves VLAN 100, in
test_md, and then create service instance 5 for test_md and test_ma.
<Sysname> system-view
[Sysname] cfd md test_md level 3
[Sysname] cfd ma test_ma md test_md vlan 100
[Sysname] cfd service-instance 5 md test_md ma test_ma
cfd version
Syntax
cfd version { draft5 | draft5-plus | standard }
undo cfd version
View
System view
Default Level
2: System level
Parameters
draft5: Specifies that IEEE 802.1ag draft5.2 be used.
draft5-plus: Specifies that the IEEE 802.1ag draft5.2 interim version be used.
standard: Specifies that the standard version of IEEE 802.1ag be used.
Description
Use the cfd version command to configure the CFD protocol version.
Use the undo cfd version command to restore the default.
By default, CFD uses the standard version of IEEE 802.1ag.
Examples
# Configure the CFD protocol version as IEEE 802.1ag draft5.2.
<Sysname> system-view
[Sysname] cfd version draft5

display cfd linktrace-reply

Syntax
display cfd linktrace-reply [ service-instance instance-id [ mep mep-id ] ]
View
Any view
1-12