Mld-Snooping Last-Listener-Query-Interval - H3C S3100 Series Command Manual

This command works on MLD snooping–enabled VLANs, and the version of MLD on the simulated
host depends on the version of MLD snooping running in the VLAN.
The source-ip ipv6-source-address option in the command is meaningful only for MLD snooping
version 2. If MLD snooping version 1 is running, although you can include source-ip
ipv6-source-address in your command, the simulated host responses with only an MLDv1 report
when receiving a query message.
If configured in Ethernet interface view, this feature takes effect only if the interface belongs to the
specified VLAN.
Examples
# Configure Ethernet 1/0/1 in VLAN 2 to join (2002::22, FF3E::101) as a simulated host.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping version 2
[Sysname-vlan2] quit
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1] mld-snooping host-join ff3e::101 source-ip 2002::22 vlan 2

mld-snooping last-listener-query-interval

Syntax
mld-snooping last-listener-query-interval interval
undo mld-snooping last-listener-query-interval
View
VLAN view
Default Level
2: System level
Parameters
interval: MLD last listener query interval in units of seconds, namely the length of time the device waits
between sending IGMP multicast-address-specific queries. The effective range is 1 to 5.
Description
Use the mld-snooping last-listener-query-interval command to configure the MLD last-listener query
interval in the VLAN.
Use the undo mld-snooping last-listener-query-interval command to restore the system default.
By default, the MLD last listener query interval is 1 second.
This command takes effect only if MLD snooping is enabled in the VLAN.
Related commands: mld-snooping enable, last-listener-query-interval.
Examples
# Enable MLD snooping and set the MLD last-listener query interval to 3 seconds in VLAN 2.
<Sysname> system-view
[Sysname] mld-snooping
2-14