H3C S3100 Series Command Manual page 1090

[sysname] interface Ethernet1/0/2
[sysname-Ethernet1/0/2] arp filter binding 192.168.100.1 000d-88f8-528c
arp max-learning-num
Syntax
arp max-learning-num number
undo arp max-learning-num
View
VLAN interface view
Parameters
number: Maximum number of dynamic ARP entries that can be learned by the interface. it ranges from
1 to 256.
Description
Use the arp max-learning-num command to configure the maximum number of dynamic ARP entries
that can be learned by the current VLAN interface.
Use the undo arp max-learning-num command to remove the configuration.
By default, the maximum number of dynamic ARP entries that can be learned by a VLAN interface is not
configured.
Note that:
If you execute this command repeatedly, the last configured command takes effect.
Among S3100 series switches, only S3100-EI series switches support the two commands.
Examples
# Configure the maximum number of dynamic ARP entries that can be learned by VLAN-interface 40 as
50.
<sysname> system-view
[sysname] interface vlan-interface 40
[sysname-Vlan-interface40] arp max-learning-num 50
ip source static import dot1x
Syntax
ip source static import dot1x
undo ip source static import dot1x
View
System view
Parameters
None
3