H3C S3100 Series Command Manual page 693

Examples
# Set the interval between sending NDP packets to 80 seconds.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] ndp timer hello 80
reset ndp statistics
Syntax
reset ndp statistics [ interface interface-list ]
View
User view
Parameters
interface-list: Ethernet port list, in the format of { interface-type interface-number [ to interface-type
interface-number ] } &<1-10>, where to is used to specify a port range, and &<1-10> means that you
can provide up to ten port indexes/port index ranges for this argument. The interface-number argument
is in the format of unit ID/slot number/port number.
Description
Use the reset ndp statistics command to clear the NDP statistics on specific ports. When executing
the command, if you specify the interface keyword, the command will clear NDP statistics on the
specified ports; if you do not specify the interface keyword, the command will clear NDP statistics on all
ports.
You can use the display ndp command to view the NDP statistics before and after the execution of the
reset ndp statistics command to verify the execution result.
Examples
# Display the NDP statistics on port Ethernet 1/0/6.
<Sysname> display ndp interface ethernet 1/0/6
Interface: Ethernet1/0/6
Status: Enabled, Pkts Snd: 1, Pkts Rvd: 2, Pkts Err: 0
# Clear the NDP statistics on port Ethernet 1/0/6.
<Sysname> reset ndp statistics interface ethernet 1/0/6
# Re-display the NDP statistics on port Ethernet 1/0/6.
<Sysname> display ndp interface ethernet 1/0/6
Interface: Ethernet1/0/6
Status: Enabled, Pkts Snd: 0, Pkts Rvd: 0, Pkts Err: 0
2-5