Ip Pimsm Mode; Ip Pimsm Query-Interval; Ip Pimsm Spt-Threshold - Planet Networking & Communication WGS3-24000 User Manual

▫
Mode Global Config

13.5.6 ip pimsm mode

This command sets administrative mode of PIM-SM multicast routing on a routing interface to enabled.
▫
Default disabled
▫
Format ip pimsm mode
▫
Mode Interface Config
no ip pimsm mode
This command sets administrative mode of PIM-SM multicast routing on a routing interface to disabled.
▫
Format no ip pimsm mode
▫
Mode Interface Config

13.5.7 ip pimsm query-interval

This command configures the transmission frequency of hello messages in seconds between PIM enabled neighbors. This field
has a range of 10 to 3600 seconds.
▫
Default 30
▫
Format ip pimsm query-interval <10-3600>
▫
Mode Interface Config
no ip pimsm query-interval
This command resets the transmission frequency of hello messages between PIM enabled neighbors to the default value.
▫
Format no ip pimsm query-interval
▫
Mode Interface Config

13.5.8 ip pimsm spt-threshold

This command is used to configure the Threshold rate for the RP router to switch to the shortest path. The rate is specified in
Kilobytes per second. The possible values are 0 to 2000.
▫
Default 50
▫
Format ip pimsm spt-threshold <0-2000>
▫
Mode Global Config
no ip pimsm spt-threshold
This command is used to reset the Threshold rate for the RP router to switch to the shortest path to the default value.
▫
Format no ip pimsm spt-threshold
512