D-Link Discovery Protocol Commands; Enable Ddp; Disable Ddp - D-Link DGS-1100-16/ME Reference Manual

D-LINK DISCOVERY PROTOCOL COMMANDS

The D-link Discovery Protocol (DDP) commands in the Command Line Interface (CLI) are listed (along
with the appropriate parameters) in the following table.
Command

enable ddp

disable ddp

config ddp report_time
show ddp
Each command is listed in detail, as follows:
enable ddp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable DDP support
DGS-1100-24P/ME:admin#enable ddp
Command : enable ddp
Success.
DGS-1100-24P/ME:admin#
disable ddp
Purpose
Syntax
Description
Parameters
Restrictions
DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
Parameter
[30 | 60 | 90 | 120 | never]
To enable DDP support of the switch.
enable ddp
The enable ddp command enables DDP support of the switch.
None.
Only administrator-level users can issue this command.
To disable DDP support of the switch.
disable ddp
The disable ddp command disables DDP support of the switch.
None.
Only administrator-level users can issue this command.
137
27