ip dvmrp metric
Use this command to configure the metric associated with a set of destinations for DVMRP
reports.
Syntax
ip dvmrp metric metric
Parameters
metric
Defaults
None.
Mode
Interface configuration: C3
Usage
To reset the DVMRP metric back to the default value of 1, enter ip dvmrp metric 1.
Example
This example shows how to set a DVMRP of 16 on the VLAN 1 interface:
C3(su)->router(Config-if(Vlan 1))#ip dvmrp metric 16
show ip dvmrp
Use this command to display DVMRP routing information.
Syntax
show ip dvmrp [route | neighbor | status]
Parameters
route | neighbor |
status
Defaults
If no optional parameters are specified, status information will be displayed.
Mode
Any router mode.
Example
This example shows how to display DVMRP status information:
C3(su)->router#show ip dvmrp
Vlan Id
Specifies a metric associated with a set of destinations for DVMRP
reports. Valid values are from 1 to 31.
(su)->router(Config-if(Vlan 1))#
(Optional) Displays, DVMRP routing information, neighbor information,
or DVMRP enable status.
Metric
Admin Status
Oper. Status
Enterasys C3 Configuration Guide 27-27
ip dvmrp metric