Handshake Timeout - HP E4510-48G Command Reference Manual

Table 12-2 display ssl server-policy command output description
Field
SSL Server Policy
PKI Domain
Ciphersuite

Handshake Timeout

Close-mode
Session Timeout
Session Cachesize
Client-verify
handshake timeout
Syntax
handshake timeout time
undo handshake timeout
View
SSL server policy view
Default Level
2: System level
Parameters
time: Handshake timeout time in seconds, in the range 180 to 7,200.
Description
Use the handshake timeout command to set the handshake timeout time for an SSL server policy.
Use the undo handshake timeout command to restore the default.
By default, the handshake timeout time is 3,600 seconds.
If the SSL server does not receive any packet from the SSL client before the handshake timeout time
expires, the SSL server will terminate the handshake process.
Related commands: display ssl server-policy.
Examples
# Set the handshake timeout time of SSL server policy policy1 to 3,000 seconds.
SSL server policy name
PKI domain used by the SSL server policy
Cipher suite supported by the SSL server policy
Handshake timeout time of the SSL server policy, in seconds
Close mode of the SSL server policy, which can be:
wait disabled: In this mode, the server sends a close-notify
message to the client and then closes the connection
immediately without waiting for the close-notify message of
the client.
wait enabled: In this mode, the server sends a close-notify
message to the client and then waits for the close-notify
message of the client. Only after receiving the expected
message, does the server close the connection.
Session timeout time of the SSL server policy, in seconds
Maximum number of buffered sessions of the SSL server policy
Whether client authentication is enabled
12-5
Description