Rrpp Configuration Commands; Control-Vlan - HP E4510-48G Command Reference Manual

3

RRPP Configuration Commands

RRPP Configuration Commands

control-vlan

Syntax
control-vlan vlan-id
undo control-vlan
View
RRPP domain view
Default Level
2: System level
Parameters
vlan-id: Specifies a VLAN as the primary control VLAN for the RRPP domain, in the range 2 to 4093.
This VLAN must be one not created yet.
Description
Use the control-vlan command to specify the primary control VLAN for the current RRPP domain.
Use the undo control-vlan command to remove the control VLANs configured for the current RRPP
domain.
Note that:
When configuring control VLANs for an RRPP domain, you only need to configure the control
VLAN for the primary ring, that is, the primary control VLAN. The system will automatically
configure the VLAN whose VLAN ID is the primary control VLAN ID plus 1 as the secondary
control VLAN for subrings. Like the primary control VLAN, the secondary control VLAN must be
one not created yet. For the control VLAN configuration to be successful, you must make sure that
the IDs for the two control VLANs have not been assigned yet.
Before configuring RRPP rings for an RRPP domain, you can delete or modify the control VLANs
configured for the RRPP domain. However, after configuring RRPP rings for an RRPP domain,
you cannot delete or modify the control VLANs of the domain.
You cannot use the undo vlan all command to delete a control VLAN.
Related commands: rrpp domain.
Examples
# Configure VLAN 100 as the primary control VLAN of RRPP domain 1.
<Sysname> system-view
[Sysname] rrpp domain 1
3-1