Ip Check Source - HP E4510-48G Command Reference Manual

Table 9-2 display user-bind command output description
Field
Total entries found
MAC
IP
Vlan
Port
Status

ip check source

Syntax
ip check source { ip-address | ip-address mac-address | mac-address }
undo ip check source
View
Ethernet interface view, VLAN interface view
Default Level
2: System level
Parameters
ip-address: Specifies to bind source IP address to the port.
ip-address mac-address: Specifies to bind source IP address and MAC address to the port.
mac-address: Specifies to bind source MAC address to the port.
Description
Use the ip check source command to configure the dynamic binding function on a port.
Use the undo ip check source command to restore the default.
By default, the dynamic binding function is disabled.
Note that:You cannot configure the dynamic binding function on a port that is in an aggregation group.
Related commands: display ip check source.
Examples
# Configure dynamic binding function on port GigabitEthernet1/0/1 to filter packets based on both
source IP address and MAC address.
<Sysname> system-view
[Sysname] interface gigabitethernet1/0/1
[Sysname-GigabitEthernet1/0/1] ip check source ip-address mac-address
Total number of found entries
MAC address of the binding. N/A means that no MAC address is
bound in the entry.
IP address of the binding. N/A means that no IP address is bound in
the entry.
VLAN of the binding. N/A means that no VLAN is bound in the entry.
Port of the binding
Type of the binding. Static means that the binding is manually
configured.
9-3
Description