Smart-Link Group - HP E4510-48G Command Reference Manual

Note that:
If no VLAN is specified, VLAN 1 applies.
This command cannot be used on member port of an aggregation group or service loopback
group.
Related commands: flush enable.
Examples
# Enable GigabitEthernet 1/0/1 to process the flush messages received in VLAN 1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] smart-link flush enable
# Enable Layer-2 aggregate interface 1 to process the flush messages received in VLAN 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] smart-link flush enable

smart-link group

Syntax
smart-link group group-id
undo smart-link group group-id
View
System view
Default Level
2: System level
Parameters
group-id: Smart link group ID. The minimum value is 1, while the maximum value is 26.
Description
Use the smart-link group command to create a smart link group and enter smart link group view.
Use the undo link-aggregation group command to remove a smart link group.
Note that a smart link group with member ports cannot be removed.
Examples
# Create smart link group 1 and enter smart link group view.
<Sysname> system-view
[Sysname] smart-link group 1
[Sysname-smlk-group1]
1-9