If-Match Tag - HP E4510-48G Command Reference Manual

View
Route policy view
Default Level
2: System level
Parameters
interface-type: Interface type
interface-number: Interface number
&<1-16>: Indicates the argument before it can be entered up to 16 times.
Description
Use the if-match interface command to specify interface(s) for matching against the outbound
interface of routing information.
Use the undo if-match interface command to remove the match criterion.
The match criterion is not configured by default.
Related commands: if-match acl, if-match ip-prefix, if-match ip next-hop, if-match cost, if-match
tag, route-policy, apply ip-address next-hop, apply cost, apply tag.
Examples
# Configure node 10 in permit mode of route policy policy1 to permit routing information with the
outbound interface as VLAN-interface 1.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match interface vlan-interface 1

if-match tag

Syntax
if-match tag value
undo if-match tag
View
Route policy view
Default Level
2: System level
Parameters
value: Specifies a tag from 0 to 4294967295.
Description
Use the if-match tag command to match routing information having the specified tag.
Use the undo if-match tag command to remove the match criterion.
The match criterion is not configured by default.
6-5