Sflow Sampling-Rate - HP E4510-48G Command Reference Manual

sflow sampling-rate

Syntax
sflow sampling-rate rate
undo sflow sampling-rate
View
Ethernet port view
Default Level
2: System level
Parameters
rate: Number of packets, in the range of 1000 to 500000.
Description
Use the sflow sampling-rate command to specify the number of packets out of which the interface will
sample a packet.
Use the undo sflow sampling-rate command to restore the default.
By default, the packet sampling rate is 200000.
Note that this command should be used after sFlow is enabled on the current port.
Examples
# Specify the interface to sample a packet out of 100000 inbound packets.
<Sysname> system-view
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] sflow enable inbound
[Sysname-GigabitEthernet1/0/1] sflow sampling-rate 100000
13-6