Patch Install - HP E4510-48G Command Reference Manual

Examples
# Delete patch 3 and all the patches before patch 3 on the device with member ID being 1.
<Sysname> system-view
[Sysname] patch delete 3 slot 1

patch install

Syntax
patch install patch-location
undo patch install
View
System view
Default Level
3: Manage level
Parameters
patch-location: A string consisting of 1 to 64 characters. About the switch 4510G, the location is "flash:".
Description
Use the patch install command to install all the patches in one step.
Use the undo patch install to remove the patches.
After you execute the patch install command, a message "Do you want to continue running patches
after reboot? [Y/N]:" is displayed.
Entering y or Y: All the specified patches are installed, and turn to the RUNNING state from IDLE.
This equals execution of the commands patch location, patch load, patch active, and patch
run. The patches remain RUNNING after system reboot.
Entering n or N: All the specified patches are installed and turn to the ACTIVE state from IDLE.
This equals execution of the commands patch location, patch load and patch active. The
patches turn to the DEACTIVE state after system reboot.
Note that:
Before executing the command, save the patch files to root directories of the member devices'
storage media.
The patch install command changes the patch file location specified with the patch location
command to the directory specified by the patch-file argument of the patch install command. For
example, if you execute the patch location xxx command and then the patch install yyy
command, the patch file location automatically changes from xxx to yyy.
Examples
# Install the patches located on the flash.
<Sysname> system-view
[Sysname] patch-install flash:
Patches will be installed. Continue? [Y/N]:y
Do you want to run patches after reboot? [Y/N]:y
17-4