Mld-Snooping Query-Interval - HP E4510-48G Command Reference Manual

Parameters
None
Description
Use the mld-snooping querier command to enable the MLD Snooping querier function.
Use the undo mld-snooping querier command to disable the MLD Snooping querier function.
By default, the MLD Snooping querier function is disabled.
Note that:
This command takes effect only if MLD Snooping is enabled in the VLAN.
This command does not take effect in a sub-VLAN of an IPv6 multicast VLAN.
Related commands: subvlan command in IPv6 Multicast VLAN Commands in the IP Multicast
Volume.
Examples
# Enable the MLD Snooping querier function in VLAN 2.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping querier

mld-snooping query-interval

Syntax
mld-snooping query-interval interval
undo mld-snooping query-interval
View
VLAN view
Default Level
2: System level
Parameters
interval: MLD query interval in seconds, namely the length of time the device waits between sending
MLD general queries. The effective range is 2 to 300.
Description
Use the mld-snooping query-interval command to configure the MLD query interval.
Use the undo mld-snooping query-interval command to restore the system default.
By default, the MLD query interval is 125 seconds.
This command takes effect only if MLD Snooping is enabled in the VLAN.
Related commands:
max-response-time.
mld-snooping querier,
3-17
mld-snooping max-response-time,